 |
 |
| Club Foot |
Pro Arm |
| We supply three types of swing arms, two are
pictured above and a third is not shown is the same as the Pro Arm
with the addition of our weld-on axle block assembly. All are
available for Kawasaki and Suzuki in 4" to 12" over stock in 2"
increments. The Club Foot would commonly be used with an 18" x 6"
wheel using an 8 1/2" wide tire. The Pro Arm would use the 15" x 9"
wheel and a 10" tire. All three versions come complete with our axle
adjusters and a heat treated 4130 chrome moly axle in your choice of
20mm, 7/8" , or 25mm . These units feature our usual high quality
and are sealed for use as a pressurized air storage unit . We can
also weld on wheelie bar mounts at the time of manufacture . |
| When ordering, please specify the following:
Make and model of frame, axle diameter desired, tire width, and
amount over stock length. |
| C200 |
Club Foot |
4" to 12" over stock |
$ 435.00 |
| C201 |
Pro Arm |
4" to 12" over stock |
$ 566.00 |
| C202 |
Pro Arm |
4" to 12" over stock with adjustable axle
height |
$ 780.00 |
| C203 |
Upper and Lower wheelie bar mounts |
add to above |
$ 145.00 |
| C205 |
Lengthen stock swing arm |
Starting at |
$ 98.00 |
 |
Our axle nuts have a large flange so there is no need to use
a washer. When ordering an axle, let us know the outside width of
the swing arm. The rear axles include two nuts, one will be heli-arc
welded to the end |
 |
PRICES SUBJECT TO CHANGE WITHOUT NOTICE
Please View Our Warranty Information Here |
